6mmProShop Gas Powered Full Metal DSR-1 Advanced Bullpup Sniper Rifle (Color: Grey)

"This is truly the best gas sniper rifle out there. Everything about it from the inside out is perfection. The only thing I did to upgrade it was put an r-hop in it but besides that nothing else needs to be modified. The magazines are super easy to tap for HPA use and is what i do when i am playing in cold weather. The ONLY con that I have is its weight. However i would much rather have a good quality piece that's heavy than a crappy gun that's super light.

"Can you put a suppressor on this gun

"Very well built gun, solid and heavy. Muzzle break is a nightmare to get off with a set pin and glued on took hours and lots of pain. Confirmed it does have positive thread. Instead of doing a pros and cons I will just list what I have found out about it.

-FPS=586 with a full mag of propane and a 6.02 inner barrel
-Accurate well past 200ft with .32's and rhop. Easily can handle heavier weights.
-Magazines are solid and non leaking.
-Bolt is fluid and easy to "rack" a bb.
-Mags hold LOTS of gas went through three full magazines of bb's and still had lots of gas left.
-You can also load the mags via a speed loader if you have the little guider you put on the end of them. Very useful.
-The top rail is not a standard RIS so using a riser wont work unless you file out a spot for it to sit down into it.(which I did) 10 minutes and you can mount your optics. If you just plan on using regular scope mounts then it doesn't matter as you can adjust the location of the mounts on the scope.
-The bipod, foregrip RIS, buttpad, cheeck rest, stock monopod are all adjustable for some fantastic customized fitting and just looks wicked awesome.
-Weighs just shy of 17lbs with mags and scope mounted.
-Inner barrel is 550mm and you WILL need an inner barrel extension if you plan to mount a silencer. Which I did and my outer barrel extends roughly 5 inches past my inner barrel without any complications so you can extend your inner barrel to a 590 if you wanted but it isn't necessary.
-Hopup looks to be like an aps2 hop unit with a few differences namely the bb guider attached to the end of it. But it adjusts just like a regular bolty with a set screw on the top through a hole in the RIS. Uses a 2mm wrench.
-Strips down very quickly, you need to disassemble it completely in order to access the hop unit and inner barrel which also means you MUST remove the muzzle break. Literally the only issue I have ran into thus far seriously.....nightmare muzzle. But that isn't the rifles fault.

Overall I due believe this weapon is beautiful and performs very well, I plan on doing some videos of it as there is jack on youtube for it but that won't be for awhile. Hopefully I helped someone who was curious and or was looking for some information about the rifle.

Solid 11/10