LCT Airsoft Z Series ZB-11 Tactical Railed Handguard for AK AEG / GBB Rifles

"this handguard is great. with slight modification it fit on my E&L essential line AK74MN. in order to make it fit, you need to dremel down the side lips that lock into the body. don’t be gentle with it and think that you’ll make it fit by taking the top layer of paint off as i personally dremeled off around 1/8th of an inch when accounting for both sides. after it was close to fitting, i took a rubber mallet and beat it half to death and it locked in nicely. i slid the locking collar back and fastened it and it’s as solid as a rock. i even took the gun and jerked it up and down as hard as i could by the added foregrip i installed and there was no play, no wobble, no noise. they even took the time to print legit Zenitco markings on the side of the rail kit and i think that might just be my favorite part. it adds a bit of front weight, HOWEVER if you own an LCT or E&L ak it’s very clear that weight is not of your concern whatsoever. it definitely added the much needed modern touch that i was hoping for. it made me smile, thank you.

"It fits snugly on my cyma. It was a little difficult to get on but shouldn't take more than 10 minutes to install. My only complaint was to get my vfg off was i need to disassemble the gun. It could be a deign flaw inherent to the aks74u but i don't know for certain.

"Fits great on my LCT AK74U with no modification needed! I combined this lower with a 5KU B-19 upper and it's a perfect fit! Not much to say about it. It's from LCT so it's already high quality.

Pro:
Perfect and tight fit on my LCT AK74U with no modification.
Fits 5KU B-19 upper perfectly.
High quality.

Con:
none

Grab it for your AK74U. You won't regret it.

"Fits perfectly on my GHK Ak74u with minimal work. Use the larger brick piece, sand it a bit, then bop it into place with a rubber mallet for a solid fit.

"Great handguard fits my CYMA AKS74u just fine without wobble, good quality finish and the piece is very study. Comes with an Allen key as well for the screws and a fatter rear bracket if the handguard is a loose fit to the receiver.

Just be cautious of the rails themselves they seem to be ever so slightly bigger than standard piccatiny rails so some foregrips may be a tight fit but that's not an issue.

Good product overall would recommend!