Maple Leaf CNC Machined Steel 2020 Version Zero Trigger Box Set for VSR-10 Airsoft Sniper Rifles (Model: 90 Degree)

"Fit right into my CYMA CM701 without issue, trigger pull is smooth and light, a bit too light actually as sometimes it's hard to feel exactly where the point of release is. My only complaint is that unlike other vsr-10 triggers, the safety is a simple stamping held down by a screw instead of being a molded piece held down by a spring, which makes it a bit painful to move at times.

"I installed this trigger on my cyma vsr10 and I’m happy with the results. The secondary safety didn’t seem to make much sense to me on how it worked so I took it off. The main safety works great and is part of the reason I decided to go with this zero trigger versus others that don’t have a safety at all. This trigger is easy to take apart if you ever need to get inside for clean up. The length of trigger pull is adjustable with a little Allen screw and allows for some very nice fine tuning.

I wish I hadn’t purchased the spring guide piston combo as I didn’t care for the piston too much and ended up replacing with an action army piston, but would be a good purchase if on a budget.

Pros:
Adjustable trigger pull
Easy to disassemble
Easy instal
Quality feel
Has a safety switch

Cons:
Secondary safety didn’t make much sense and was removed

"Slapped this into my WELL VSR-10 and it fit perfectly. It performs amazingly and exactly as you would want.

Only change I made was (very easy) I swapped out the safety switch for the stock one.

"Bought this for a JG VSR-10 G-Spec. In the pictures the sear and the guide bar looks silver and cnc machined. The actual part I got had sear and bar that looked coated and cast, not cnc'd. The screws that mount the trigger were too small. The screws that are on the JG are m4-.70 where the ones that came with this are smaller. Will need to make the mounting holes on the trigger slightly bigger and buy some m4-.70 10mm long screws. The secondary bolt handle safety doesn't work as the lip on the receiver sticks out enough to block the lever from engaging when the bolt handle is up. Other than that I was able to mount the trigger and it works well. Not a crisp snappy pull, a bit on the mushy side but it is light.
The piston the trigger came with feels looser than the one the gun came with but shoots 10FPS faster. A slightly thicker O-ring may seal better. You can use the original trigger guard without modification. If you have a JG VSR-10 GSpec it isnt plug and play but if you know your way around a Dremel I think it is worth it.