Strike Industries Magwell for Polymer80 PF940C and PF940v2 Frames

"Very nice polymer magwell from Strike Industries. I bought this to use it on my GBBP that had a JDG P80 Frame. Out of the box, it did not fit my P80 frame at all, so be aware if that is the frame you want to use this magwell with.

I was able to get this magwell to work with my JDG P80 frame, after some heavy modification to my frame. With a Dremel and sanding bits, I had to sand down the lower end of the magwell significantly to give the magwell more room. I also had to cut a deep groove inside the P80 frame to get the part of the magwell with the screwhole to go deep enough into the frame. Lastly, I had to sand the magwell a bit once locked into the frame because my WE mags would get stuck on the gap between the magwell and frame (the little tab WE mags have on the back of the magazines).

Since I was doing this carefully, it took me about an hour of tooling to get this to work. Wasn't necessarily difficult, but it did take some time and was not a drop in fit. Keep this in mind when buying. If this isn't an issue for you, then it is a nicely made magwell that does look good once attached.