(626) 286-0360
Airsoft
Fishing
Air Gun
DyTac Drop-In MOSFET Unit (Rear Wiring / T Plug)
8 Customer Reviews
by Trevor C. on 09/08/2020
"I bought this to upgrade my G&G Combat Machine Raider. It took a little bit of dremeling to get it to fit, but otherwise fit fine. The black wire was extra long, for some reason, and the red wire was almost too short. But that said, it worked great with my 11.1 lipo and got great trigger response.
Note: if you have a buffer tube, a Dean’s plug (and probably a Tamiya connector) will not fit! You will still need to install banana plugs, or the like, so you can have something that will fit through the hole from the lower receiver into the buffer tube, then attach your Deans connector there.
Note: if you have a buffer tube, a Dean’s plug (and probably a Tamiya connector) will not fit! You will still need to install banana plugs, or the like, so you can have something that will fit through the hole from the lower receiver into the buffer tube, then attach your Deans connector there.
by Isaac J. on 08/07/2020
"Not a bad little drop in mosfet, basic mosfet to protect trigger contacts. Simple well priced, will buy more
by Van D. on 07/12/2020
"Very good cheap mosfet to replace standard contact
by Christian G. on 02/27/2020
"Bought this for a CYMA M4.
Definitely fits in the gearbox without modification but holy hell was it difficult to install properly, I had to remove the cutoff lever and safety switch to do so, can't remember if that's the usual procedure though, but I did eventually fit it inside the gearbox shell.
As the previous reviews have mentioned it does NOT come with a trigger shuttle or retaining screw so save those for the install.
Definitely buying more of these later on.
Definitely fits in the gearbox without modification but holy hell was it difficult to install properly, I had to remove the cutoff lever and safety switch to do so, can't remember if that's the usual procedure though, but I did eventually fit it inside the gearbox shell.
As the previous reviews have mentioned it does NOT come with a trigger shuttle or retaining screw so save those for the install.
Definitely buying more of these later on.
by Washington T. on 11/23/2019
"This was in my Dytac SLR. I repurposed it for another build. It’s a quick drop-in with no modification and works as it should. Nice product.
by Spencer A. on 01/01/2022
"All in all it's a great little mosfet, super easy install and it added some much needed improved trigger response to my CYMA M4 project and handled the 11.1V Lipo great. That being said, the wire lengths seemed to be different (could have just been a lemon) which made getting my front motor connection a bit of a pain but once I got it, it wasn't going anywhere and the gun has been great with no problems since.
by DIANA N. on 09/18/2020
"I've bought 2 of these mosfets and I have to say, ts not a bad mosfet, works great however maybe its just me but both of the mosfets I've tried basically killed themselves after using an 11.1v 25c lipo battery.
by Chester F. on 02/02/2020
"Purchased dytac drop in unit but does not seem to be working. I assume all you have to do is connect wires but to no avail. Took a multi meter and seems ground wire not continuous. Not sure what im doing wrong Pls help!